MTN PRO Acrylic Varnish 400ml

If you are looking to increase surface protection while simultaneously enriching the shine of the various surfaces, the

MTN PRO Acrylic Varnish will come in very handy. It is a solvent-based, thermoplastic resin, acrylic spray varnish or lacquer, Suitable for protecting, enhancing and embellishing surfaces. It dries really fast and comes in gloss, satin and matte finishes.

Different finishes can be obtained depending on the number of coats applied.

See below for more Product and Usage information

Fast drying, thermoplastic acrylic resin-based varnish. Available in glossy, satin finish and matte.

FEATURES

On newly painted surfaces or old paint, do a test first in order to see the results, as the varnish may crack the previous layer.

APPLICATIONS

Acrylic varnish could be applied to many materials to protect them and at the same time to enhance their brightness. Different finishes are obtained depending on the number of coats applied.

Wood
Painted materials
Wicker
Cork
Steel
Stone
Serval plastics
In general, all surfaces that can be varnished

Weight	0.30 kg
Dimensions	20 × 6.5 cm
INSTRUCTIONS FOR USE	– Before using, shake the aerosol vigorously for approximately one minute. – Apply over clean and dry surfaces. On rusty metallic surfaces: Remove corrosion with a wire brush. In plastics like PS and PP apply first a primer layer. See product’s behavior in any plastic surface. – Apply thin coats for better results, better three thin layers than a thick one. It is recoatable after ten minutes. – Hold the aerosol upside down after use to purge the valve. If the nozzle is blocked, replace it with a new one. – Do not apply on plugged-in electrical equipment and use in well-ventilated areas. – When applied over other paints do a preliminary test first, as sometimes the varnish can remove paint on the surface to be varnished

Weight

0.30 kg

Dimensions

20 × 6.5 cm

INSTRUCTIONS FOR USE

– Before using, shake the aerosol vigorously for approximately one minute.

– Apply over clean and dry surfaces. On rusty metallic surfaces: Remove
corrosion with a wire brush. In plastics like PS and PP apply first a primer layer.
See product’s behavior in any plastic surface.

– Apply thin coats for better results, better three thin layers than a thick one.
It is recoatable after ten minutes.

– Hold the aerosol upside down after use to purge the valve. If the nozzle
is blocked, replace it with a new one.

– Do not apply on plugged-in electrical equipment and use in well-ventilated areas.

– When applied over other paints do a preliminary test first, as sometimes
the varnish can remove paint on the surface to be varnished